Effects

You can manually run Beam Effects and Move Effects via the respective tabs on the Console.

The Move Effects and Beam Effect tabs are Manual Controls only.

Move Effects

You can apply the effect to one or many groups, by selecting/deselecting the Groups name. Selected groups are highlighted in Green.

You can then adjust the Speed, Size and Fan of the effect(only applies to Fan Effects).

Speed

The speed setting will increase or decrease the speed of the movement. Can be adjusted live whilst the effect is running.

Size

The size setting will change how wide or narrow the moving heads will move, the smaller the size the closer to their center point they will remain, the higher the more wide and sweeping the effect. Can be adjusted live whilst the effect is running.

Phase (Fan)

The phase setting option allows you to alter the timing of each movement for each moving head, 0 is in phase and all heads should move in the same way, but as you adjust the phase positive or negative they will move in/out of phase.

Fanning (Fan)

The fan setting will adjust either the Pan or Tilt so that fixtures are "Fanned Out" or "Fanned In", 0 is no fanning applied. Depending on the effect, this will either fan the Pan or Tilt channel. For example, when using the Up/Down effect it will fan the Pan channels, whilst when using the Left/Right effect, it will fan the Tilt channels.

My Sequences

If you have defined any custom movement sequences, which is possible from the Pan/Tilt Finder tab, they they will appear in this section, you can activate/deactivate them the same as any other Move Effect.

Gobos & Prisms

If your movers have Gobos or Prisms defined, you can control their activation by clicking on the item you want to activate. By default, none are activated.

Beam Effects

You can apply the effect to one or many groups, by selecting/deselecting the Groups name. Selected groups are highlighted in Green.

You can then adjust the Speed and Background Lighting using the sliders.

You can switch on and off any single effect by clicking on the effect in the effects panel.

Colors

If you select no Color then the effect will default to RGBWAUV or whatever base colors are available from your fixtures configuration.

If you select 1 single color this color will be applied to every fixture, if available. Selecting multiple colors will light multiple lamps.